Very forgiving with little to no stringing
Printed on Prusa i3 MK3S+ with a Revo E3D 0.4 nozzle in an enclosure that was kept open for printing
Layer height .2mm, print speeds at 40mm/s
flow at 97%
Print fan on @ 100%
Very forgiving with little to no stringing, tried nozzle temps from 190 – 215, retraction setting close to default on PrusaSlicer PLA.
Attached picture was printed at 190 degrees- nozzle with smooth steel bed temp at 50 degrees, over hangs printed relatively clean.
filament was dried in an eSun filament dryer 5 hours before printing this one, however, I did print a benchy from right out of the package and it was fine.
It was nice to be able to print some sample prints without a strong odour and a definite plus nowing it is 100% biodegradable.
Thank you for the opportunity to Beta test this fine product!
samples are in the mail.